CHARACTERISTICS OF MOVEMENTS WHEN CYLINDRICAL TURNING, DRILLING, COREDRILLING AND REAMING
DOI:
https://doi.org/10.17770/etr2023vol3.7259Keywords:
characteristics of movement, coordinate axes, cutting and feed motion, resultant cutting motionAbstract
In the process of work the tool angles change their value to become the working angles. This results in a variation of the work conditions of the cutting tools. The variation depends on the characteristic of the resultant cutting motion – the sum of the cutting motion and feed motion.
In this article the characteristics of motions of cylindrical turning, drilling, coredrilling and reaming are derived, which can serve as a basis for determining the relations between the tool and working angles.
These relations can be used in programming the CNC to prevent the formation of negative working clearance angle and the destruction of the tool.
Downloads
References
V. Astakhov, Geometry of Single-Point Turning Tools and Drills: Fundamentals and Practical Applications. Springer, 2010, pp .565
A. Vachev, Conversion Methodology to Relate Tool and Working Angles – an Alternative to ISO 3002/2, Journal of the Technical University at Plovdiv, “Fundamental Sciences and Applications”, Vol. 13 (6), 2006. Anniversary Scientific Conference’ 2006, Plovdiv, Bulgaria, (In Bulgarian), pp. 51-58.
S. Radzevich, Geometry of the Active Part of Cutting Tools (in the Tool-in-Hand System), SME Paper TPO 6PUB37:10, 2006.
S. Radzevich, Geometry of the Active Part of Cutting Tools (in the Tool-in-Use System), SME, 2006.
M. Aleksiev, Machining by rotary cutting on CNC Machine, M.S. thesis, Technical University of Sofia, Sofia, Bulgaria, 2018
M. Aleksiev, Grapho-analytical method for determining the working angles of turning tools, Journal of the Technical University at Plovdiv, Vol. `21 (2), 2015, Scientific Conference Techsys-2015, Plovdiv, Bulgaria, (In Bulgarian), pp. 61.
ISO 3002/2-1984(E), Basic quantities in cutting and grinding - Part 2: Geometry of the active part of cutting tools - General conversion formulae to relate tool and working angles.
A. Vachev and A. Poparov, Tool in use system and motion angles when turning, Journal of the Technical University at Plovdiv, “Fundamental Sciences and Applications”, Vol. 13 (6), 2006. Anniversary Scientific Conference’ 2006, Plovdiv, Bulgaria, (In Bulgarian), pp. 59-70.
A. Vachev and A. Poparov, Tool in hand and tool in use systems when boring (3D), drilling, counterboring and reaming, Journal of the Technical University at Plovdiv, “Fundamental Sciences and Applications”, Vol. 13 (6), 2006. Anniversary Scientific Conference’ 2006, Plovdiv, Bulgaria, (In Bulgarian), pp. 85-92.
ISO841-1974(Е), Numerical control of machines - Axis and motion nomenclature
