# Accelerated method for the determination of freeze-thaw resistance of concrete

## DOI:

https://doi.org/10.17770/etr2015vol1.205## Keywords:

concrete, freeze-thaw resistance, permanent set, durability, monitoring of strength, freese-thaw cycling## Abstract

Main purpose of this research is to create the new reference method of determining the freeze-thaw resistance of concrete that is characterized by small labor input, high efficiency and a wide application scope. The offered method is based on measurement of long strength by nondestructive method. During this research, the theoretical analysis of concrete's specimen dependence on freeze-thaw resistance and energy, which is emitted by a specimen during destruction, has been carried out. Freeze-thaw resistance of a specimen is calculated as the mathematical relation of these energies, and the freeze-thaw resistance of concrete is calculated as an arithmetic mean value across specimens.

To prove the method correctness it was realized on 10 concrete specimens. Age of specimens cosolidation is 88 days. Speciments of concrete mortar were prepared using a mix of portland cement 400 (12,3%), sand of dimentions 0.6-5 mm (24,7%), granite macadam of dimentions 5-20 mm (55,4%) and water (7,4%). Freeze-thaw resistance such mortar was determed earlier by method, approved national standard specification, it was equal 105 cycles. According dimentions by new offered method freeze-thaw resistance such mortar is equal 107 cycles and its confidence interval is equal 5,4 (probability P = 0,95). Therefore, spread of results could be casual and the offered method is correct.

## Downloads

## References

T.F. Rønning, “Freeze-Thaw Resistance of Concrete Effect of : Curing Conditions, Moisture Exchange and Material” Phd. thesis, Norwegian Insitute of Technology, Norway. 2001.

V. Pukhkal, V. Murgul, S. Kondić, M. Živković, M. Tanić, N. Vatin, “The Study of Humidity Conditions of the Outer Walls of a “Passive House” for the Climatic Conditions of Serbia, City Nis”, Applied Mechanics and Materials, vols. 725-726, pp. 1557-1563, 2015.

G.I. Gorchakov, M.M. Kapkin and B.G. Skramtaev, Povyshenie morozostojkosti betona v konstrukcijah promyshlennyh i gidrotehnicheskih sooruzhenij. Moskow: Strojizdat, 1965.(rus)

D. Vuksanovic, V. Murgul, N. Vatin and V. Pukhkal, “Optimization of microclimate in residential buildings”, Applied Mechanics and Materials, vol. 680, pp. 459-466, 2014.

T.N. Soldatenko, “Model identifikatsii i prognoza defektov stroitelnoy konstruktsii na osnove nechetkogo analiza prichin ih poyavleniya”, Magazine of Civil Engineering, vol. 25, pp. 52-61, 2011. (rus)

I.Garanzha and N. Vatin “Analytical methods for determination a load capacity of concrete-filled tubes under axial compression”, Applied Mechanics and Materials, 633-634, pp. 965-971, 2014.

“Concrete. Specification, performance, production and conformity”, EN 206:2013, 2013.

“Concrete testing – Hardened Concrete-Frost Resistance” SS 137244, Sweden, 2005.

RILEM TC 117-FDC, “TDC, CDF Test, Test Method for the Freeze-Thaw-Resistance of concrete with sodium chloride solution,” RILEM Publications SARL, vol.29, pp. 523-528, 1996.

RILEM TC 176-IDC, “TDC, CIF Test, Test Method of frost resistance of concrete,” RILEM Publications SARL, vol.37, pp. 743-753, 2004.

N. Bunke, “Prüfung von Beton – Empfehlungen und Hinweise als Ergänzung zu DIN 1048.” Schriftenreihe des Deutschen Ausschusses für Stahlbeton, vol.422, pp.12-15, 1991.

Concretes. Basic method for the determination of frost-resistance, GOST 10060.1-95, 1995. (rus)

Concretes. Dilatometric rapid method for the determination of frost-resistance, GOST 10060.3-95, 1995. (rus)

Concretes. Methods for the determinationof frost-resistance. General requirements, GOST 10060.0-95, 1995. (rus)

A.D. Dikun at al., “Opyt jekspressnogo opredelenija morozostojkosti betona transportnyh sooruzhenij.” Construction Materials, vol. 8, pp.55-56, 2005.(rus)

T.S. Nikolskaya, Ispol'zovanie akusticheskoj jemissii dlja prognozirovanija dolgovechnosti izdelija. The IV international conference “Problemy prognozirovanija nadezhnosti i dolgovechnosti” October 14-17, 2009, St. Petersburg, Russia. St.Petersburg: Press of the St.Petersburg Polytechical University, 2009.(rus)

T.S. Nikolskaya, “Particularity of Acoustic Emission in Ceramic Product under Partial Uploading.” Problems of Strength, vol. 1, pp.140-147, 2002.

S.V. Akimov, T.S. Nikolskaya, S.G. Nikolskiy, “Sposob opredelenija morozostojkosti kamnja,” RU Patent 2380681, July 1, 2008. (rus)

S.G. Nikolskiy, “Jekspress-kontrol’ jerozii betona.” Magazine of Civil Engineering, vol. 2, pp.39-44, 2008.(rus)

S.V. Akimov, T.S. Nikolskaya, S.G. Nikolskiy and U.G. Barabanthikov at al., “Sposob ocenki stojkosti izdelij pri nagruzhenii,” RU Patent 2442134, November 2, 2010. (rus)

S.V. Belyaeva at al., “Sposob ocenki korrozionnoj stojkosti betonnyh izdelij,” RU Patent 2449266, November 15, 2010. (rus)

S.G. Nikolskiy, “Fracture Surface Analysis of Ceramic Bare under Short- and Long-term Bending.” Problems of Strength, vol. 5, pp.133-140, 2009.

S.G. Nikolskiy, “Acoustic emission control of strength.” Problems of Strength, vol. 6, pp.102-106, 1990.

A. Gorshkov, N. Vatin, D. Nemova and D. Tarasova, “Definition of the overturning and holding moments for floor-by-floor leaning walls made from aerated concrete blocks”, Applied Mechanics and Materials, vols. 633-634, pp. 897-903, 2014.

N. Vatin, A. Gorshkov, D. Nemova, O. Gamayunova and D. Tarasova, “Humidity conditions of homogeneous wall from gas-concrete blocks with finishing plaster compounds”, Applied Mechanics and Materials, vols. 670-671, pp. 349-354, 2014.

N.I. Vatin, I.I. Pestryakov, S.S. Kiski and Z.S. Teplova, “Influence of the geometrical values of hollowness on the physicotechnical characteristics of the concrete vibropressed wall stones”, Applied Mechanics and Materials, vols. 584-586, pp. 1381-1387, 2014.

A. Ponomarev, M. Knezević, N. Vatin, S. Kiski and I. Ageev, “Nanosize scale additives mix influence on the properties of the high performance concretes”, Journal of Applied Engineering Science, vol. 12, pp. 227-231, 2014

V. Korsun, N., Vatin, A. Korsun, and D. Nemova, “Physical-mechanical properties of the modified fine-grained concrete subjected to thermal effects up to 200°С”, Applied Mechanics and Materials, 633-634, pp. 1013-1017, 2014.

L. Akimov, N. Ilenko, R. Mizharev, A. Cherkashin, N. Vatin and L. Chumadova, “Influence of Plasticizing and Siliceous Additives on the Strength Characteristics of Concrete”, Applied Mechanics and Materials, vols. 725-726, pp. 461-468, 2015.

I.N. Ahverdev, Osnovy fiziki betona. Moscow: Strojizdat, 1981.(rus)

T.S. Nikolskaya, S.G. Nikolskiy and V.P. Terentiev, Jekspress-metody ocenki dlitel'noj stojkosti betona. The III international conference “Populjarnoe betonovedenie”, February 27 - March 2, 2009, St. Petersburg, Russia. St.Petersburg: Press of the St.Petersburg Polytechical University, 2009.(rus)

T.S. Nikolskaya, S.G. Nikolskiy, “Akusticheskaja jemissija pri jerozii melkozernistogo betona.” Nauchno-tehnicheskie vedomosti SPBGPU, vol. 4, pp.242-248, 2008.(rus)

S.G. Nikolskiy, O.N. Pertseva, “Sposob opredelenya marki betona po morozostoykosty”, RU Patent 2543669, July 4, 2013. (rus)

## Downloads

## Published

## Issue

## Section

## How to Cite

*ETR*, vol. 1, pp. 170–174, Jun. 2015, doi: 10.17770/etr2015vol1.205.